Atlas Copco HBC1700II Moil Point Tool

A: The Atlas Copco HBC1700II moil point tool is made for the Atlas Copco HBC1700II hydraulic breaker: diameter 105 mm, overall length 900 mm, weight 63 kg. Just state your breaker brand and model when you order.

A: Not always. The position and shape of the retaining pin slot change with brand and model; a tool with the same diameter and length may not fit. This tool is made to the slot dimensions of the Atlas Copco HBC1700II.

A: The Atlas Copco HBC1700II moil point tool is mainly used for: primary demolition, primary breaking, trenching, scaling, recycling. According to the material table in our manual, it is recommended for non-reinforced concrete slabs, walls and foundations, and for lightly fractured or massive sedimentary rock (limestone, sandstone).

A: The standard tool is for general demolition and construction. On the dust grooved tool the grooves guide dust away from the breaking zone and reduce wear and heat. The hard rock tool is made from a high-nickel alloy with a special hardening process, for quarrying and mining.

A: We make 14 different tools for the Atlas Copco HBC1700II: moil point tools, chisel tools, pyramid tools, blunt tools, with dust grooved and hard rock options. You can reach all of them from the Other Tool Types table on this page.

A: If the Atlas Copco HBC1700II moil point tool is in stock, it ships quickly. If not, it is made in 5 working days; transport time is added depending on the shipping method.

A: Like all HKM breaker tools, the Atlas Copco HBC1700II moil point tool is warranted against manufacturing defects only. The fracture surface is examined; if the fracture started from a flaw inside the material, the tool is covered. Breakage from prying, blank firing, rotating the embedded tool or working with worn bushings is not covered.

A: Prying before the tool is fully seated, blank firing, striking one spot for too long, insufficient or wrong grease, and working with worn bushings.

A: Compare the inner diameters of the lower and upper bushings and the thrust bushing surface with the tolerances in your breaker's service manual. Worn bushings move the tool and piston off axis. The Atlas Copco HBC1700II bushings are listed in the Spare Parts section on this page.

A: It is also called “moil”, “moil point”, “moil tool”. Atlas Copco documents use “conical moil point”, “working tool”. Breaker tools in general are also known as breaker chisels, working tools or hammer tools.